Votes - 1, Average rating: 5
(
)
)
|
manual abstract
Thank you for buying a Cary Audio Design CD-306/200 Transport/Processor! , HDCD®, High Definition Compatible Digital® and Pacific Microsonics™ are either registered trademarks or trademarks of Pacific Microsonics, Inc. in the United States and/or other countries. HDCD system manufactured under license from Pacific Microsonics, Inc. This product is covered by one or more of the following: Country Patent No. United States 5,479,168 5,638,074 5,640,161 5,808,574 5,838,274 5,854,600 5,864,311 5,872,531 Australia 669114 Other patents pending. CD-306/200 CD Transport /Processor POWER DIGITAL ANALOG 96kHz / 24Bit SAMPLE-RATE CONVERTER HDCD CD AES/EBU COAXIAL TOSLINK OPEN/CLOSE PLAY STOP PREV. NEXT CD 306/200 192kHz / 24Bit HDCD PLAYER 192kHz / 24Bit AES/EBU RIGHT LEFT AES/EBU ANALOG OUTPUT TOSLINK COAXIAL AES/EBU DIGITAL INPUT AES/EBU COAXIAL TOSLINK AC POWER DIGITAL OUTPUT CARY AUDIO DESIGN, INC., CD 306/200 HDCD PLAYER MADE IN CARY, NC, U.S.A. HDCD , High Definition Compatible Digital and Pacific Microsonics are either registered trademarks or trademarks of Pacific Microsonics, Inc. in the United States and /or other countries . HDCD system manufactured under license from Pacific Microsonics, Inc. This product is covered by one or more of the following : Country Patent No. United States 5,479,168 5,638,074 5,640,161 5,808,574 5,838,274 5,854,600 5,864,311 5,872,531 Australia 669114 Other patents pending. Complies with FDA radiation performance standards, 21CFR Subchapter J This device complies with part 15 of the FCC Rules.Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Specifications P.2 Installation P.3 Operation P.4-8 Service and Care P.9 Warranty P.10 SPECIFICATIONS Operating the CD-306/200 CD Transport/Processor is a simple procedure, since each unit is designed for long term stability in virtually any home operating situation. However, if the unit is operated outside the parameters outlined in this owner’s manual, damage may result. Please read this manual carefully before putting your new Cary Audio Design CD-306/200 in operation. The following definitions are applicable to this manual. Please follow these definitions carefully. WARNING HAZARD PRESENTS PERSONAL INJURY OR DEATH Caution EQUIPMENT DAMAGE MAY OCCUR BUT NOT PERSONAL INJURY Note Proper performance of the CD PLAYER cannot be ensured if disregarded 1.1 Specifications The following section describes the CD-306/200 CD Transport/Processor basic specifications. Specifications are subject to change without notice or obligation. CD Mechanism Philips CDM12 Master Clock Jitter Below measurable levels Digital Filter Pacific Microsonics PMD-200 with HDCD decoding Digital / Analog Converters (8) Burr Brown PCM1704u Analog Filter 3rd Order Bessel Analog Outputs Balanced XLR , Single – Ended RCA Digital Outputs AES/EBU, Coaxial, Toslink Digital Input AES/EBU, Coaxial, Toslink Digital Input Sample Rate 32kHz, 44.1kHz, 48kHz, 88.2kHz and 96kHz Accepts 16, 20 or 24 bits Frequency Range …………………………………… 2 Hz - 80 kHz (192kHz) Amplitude Linearity………………………………… 0.1 dB (20Hz - 20kHz) Phase Linearity……………………………………… 3°(20 Hz - 20 kHz) Dynamic Range………………………………………120dB (1kHz) Signal-to-Noise Ratio………………………………...122dB (1kHz) Channel Separation…………………………………. 109dB (1kHz) Total Harmonic Distortion……………………………0.0008% (1kHz) Audio Output Level…………………………………..Single-Ended 3.0Vrms Balanced XLR 6.0Vrms Power Input Reconfigured at factory 100-120/200-240 Vac, 50-60 Hz Power Consumption 35 Watts P.2 INSTALLATION This section describes the unpacking and installation procedures for the CD-306/200 CD. WARNING MAKE NO ATTEMPT TO PUT THE CD 306/200 PLAYER IN SERVICE WITH THE TOP COVER REMOVED. CONTACT WITH HIGH VOLTAGE INSIDE THE CD-306/200 PLAYER CAN BE FATAL !!!!! 2.1 Unpacking All shipping containers have been specifically designed to protect their contents and special care has been taken to prevent damage under normal shipping conditions. Mishandling should be evident upon inspection of the shipping container. If CD-306/200 player mechanism or other damage is found after unpacking and visual inspection, take care not to destroy the evidence so that the shipping agent may inspect the damage. If necessary, document the damage with photographs and contact the shipping company immediately. Carefully remove your CD-306/200 CD Transport/Processor from its packing carton and examine it closely for signs of shipping damage. It is recommended to save all original packing cartons to protect your CD-306/200 from damage should you wish to store it or ship it for after-sales service. 2.2 Placement In general, the location of your new CD-306/200 is not critical. However, certain precautions must be taken to ensure optimum performance. Avoid extremely hot locations such as near radiators or other heating units. Keep the top of ...
Other models in this manual:CD Players - CD 306 (454.45 kb)