Votes - 3, Average rating: 4.7
(
)
)
|
manual abstract
4. Discs should be put back in their cases after use to avoid serious scratches that could cause the sound to skip. 5. Do not expose discs to direct sunlight, high humidity, or high temperatures for extended periods of time. Long exposure to high temperatures can warp the disc. 6. Do not stick paper, labels, or tape on the disc surface. 7. Do not write with any type of pen, pencil, or marker on the disc surface. 8. To minimize fingerprints and smudges on the signal surface, always try to hold the discs by their outer edge and center hole. USE OF THE CD MAGAZINE LOADING DISCS INTO THE MAGAZINE This CD Changer uses a specially-designed magazine to hold up to 6 compact discs. Insert discs into the magazine with the label side up as shown in Figure 1. As each disc is inserted into the magazine, the release key for that slot will be raised. The discs are numbered from 1 (bottom slot) to 6 (top slot). REMOVING DISCS FROM THE MAGAZINE To remove a disc from the magazine, press the release key for the desired disc and carefully remove the disc by holding the edge. NOTES: • Avoid touching the playing side of the disc. • Only one disc can be inserted into each slot of the magazine. Do not try to insert more than one disc into each slot as damage to the discs and magazine may occur. • This changer is not designed to play 3" (8cm) CD-Single discs. Inserting a 3" disc into the magazine, either with or without an adapter, can damage the changer and the disc. Such damage will not be covered by the Warranty on this product. • Additional CD magazines are available as accessory item ACC31MAZ from your Rampage/Audiovox dealer, or you may contact us directly at: Attention: Audiovox Corporation, Parts Division 150 Marcus Blvd. Hauppauge, NY 11788 Fig. 1 CD magazine Label side up (playing side down) (maximum 6 discs) One disc in each slot Fig. 2 Release Keys 5 LOADING THE MAGAZINE INTO THE CHANGER Completely slide the door on the changer to the right as shown in Figure 3. Making sure the top of the magazine is facing upward, gently insert it into the unit until it clicks into place, as shown in Figure 4. Slide the door of the changer fully closed and the unit is ready for operation. REMOVING THE MAGAZINE FROM THE CHANGER To remove the magazine, slide open the door on the changer and press the eject button as shown in Figure 5. NOTES: • Be sure to keep the door on the changer closed at all times when not loading or removing the magazine. Leaving the door open could allow dust, dirt and moisture to enter the changer which could cause the unit to malfunction. • To assure proper playback, it is recommended that the CD magazine be loaded with more than one disc. • When it becomes necessary to reset the changer circuitry following system installation, or due to a changer error code, the reset button (Figure 5) may be pressed to reinitialize the microprocessor circuitry and resume normal changer operation. Fig. 3 Door Fig. 4 Fig. 5 Eject Button Reset Button COMPACTDISC CHANGER DIGITALAUDIO6 DISC ACC31 BY AUDIOVOX COMPACT DISC CHANGER DIGITAL AUDIO 6 DISC ACC31 BY AUDIOVOX COMPACT DISCCHANGER DIGITAL AUDIO 6 DISC ACC31 BY AUDIOVOX RESET OPERATING INSTRUCTIONS This CD Changer is designed to operate through a compatible Rampage/Audiovox car stereo which incorporates the controls and display functions. Please check with your Rampage/Audiovox stereo specialist for recommendations of the models that will work with this changer or contact us directly at 1-800-645-4994. The specific operating instructions for the changer will be contained within the Owner's Manual of the compatible unit. SETTING UP FOR OPERATION Following the instructions in the “USE OF THE CD MAGAZINE” section of this manual, load the desired number (up to 6) of 5” (12cm) compact discs into the CD magazine and insert the magazine into the changer. DO NOT USE 3” (8cm) CD SINGLES, EITHER WITH OR WITHOUT AN ADAPTER, IN THIS CHANGER. DAMAGE TO THE CHANGER AND/OR DISC MAY OCCUR AND SUCH DAMAGE WILL NOT BE COVERED BY THE WARRANTY ON THIS PRODUCT. Turn on the car stereo and select CDC operation to access the changer. The LCD panel on the associated radio will indicate the start of disc #1 play. Adjust the volume, balance and tone to your taste by using the controls on the car stereo. When the last track on the disc has been played, the unit will automatically advance to and begin play of the next disc. When the last track on disc #6 has been played, the unit will automatically return to disc #1 and begin play again. SPECIFICATIONS Frequency Response: 20 - 20,000 Hz. ±1 dB Distortion: 0.03% @ 1 kHz. Dynamic Range: 87 dB Signal-to-Noise Ratio: 85 dB Channel Separation: 70 dB @ 1 kHz. Wow & Flutter: below measurable limits Dimensions: Changer: 11.18"W x 2.91"H 284mm x 74 mm Operating Voltage: 12 volts DC, negative ground * Due to continuing improvement, Audiovox reserves the right to change features and design without notice. x 7.42"D x 188.5mm TROUBLESHOOTING An error made in operation...