Votes - 4, Average rating: 3.8
(
)
)
|
manual abstract
2.) Turn the OFF/VOLUME knob clockwise to turn the radio ‘On’and adjust the volume level. The POWER red LED indicator comes ‘On’. 3.) Rotate the TUNING knob to select the desired station. 4.) When you are finished listening turn the OFF/VOLUME control counter clockwise until click is heard. The POWER LED indicator goes ‘Off’. Antenna Information Both the AM and FM antennas are built into the cabinet. If reception is weak you may have to change the position or location of the set until you find the position or location that provides the best reception. 9 SR5999_ib111902.p65 9 19/11/2002, 10:18 PLAYING COMPACT DISCS 1.) Slide the CD door OPEN button downward to unlock the CD door and then open the door completely. 2.) Place your CD on the center spindle with the printed label side facing out. Gently press down on the disc near the center hole to make sure the disc is properly seated on the spindle, and then close the door fully until it locks. 3.) Set the Function switch to the CD position. 4.) Turn the OFF/VOLUME knob clockwise to turn the unit ‘On’. The POWER red LEDindicator comes ‘On’. 5.) PressthePLAY/PAUSE buttontobeginCDplayback.TheCDPLAY/PAUSE green LEDindicator lights. Playback starts with track 1 and continues until the endof thedisc.Topausemomentarilyduringplayback press thePLAY/PAUSE button again. The CD PLAY/PAUSE green LED indicator flashes and the soundstops, butthe disc continues tospin. Press the PLAY/PAUSE button oncemoretocancelpauseandresumenormalplayback.TheCDPLAY/PAUSE green LEDindicator stops flashing. 6.) When the disc ends the player stops automatically. To stop playback before the disc ends press the STOP button at any time. The CD PLAY/PAUSE green LEDindicator goes out. IMPORTANT: ALTHOUGH THE PLAYER STOPS AUTOMATICALLY THE POWER IS STILL ‘ON’. TO CONSERVE BATTERY LIFE DO NOT FORGET TO TURN THE OFF/VOLUME KNOB COUNTER CLOCKWISE UNTIL A CLICK IS HEARD AND THE POWER LED INDICATOR GOES ‘OFF’. 10 SR5999_ib111902.p65 10 19/11/2002, 10:18 Skip/Search FWD / REV Buttons ss During playback press theFWD orREV buttons repeatedlytoskiptohigher or lower numbered tracks. During playback depress and hold the FWD or REV buttons to search forwardorbackwardwithinatrackathighspeedtolocateaspecificmusicalpassage. Release the buttons when you locate the desired passage and normal playback resumes at that point. Repeat Playback One Track Repeat To repeat a single track, begin playback and skip to the desired track. Press the REPEAT button once; the REPEAT amber LED indicator flashes. The selected track will be repeated continuously. All Tracks Repeat Begin playback and press the REPEAT button twice. The REPEAT amber LED indicator remains ‘On’. The entire disc will be repeated continuously. Tocancelrepeatplayback presstheREPEAT buttonuntiltheREPEATLEDindicator goes ‘Off’.Repeatplayback canalsobecanceledbyopeningtheCDdoor,switching to radio function, or turning the power ‘OFF’. 11 SR5999_ib111902.p65 11 19/11/2002, 10:18 HEADPHONE JACK The headphone jack is located on the right side of the cabinet and covered by a silicon rubber gasket. Lift the gasket to expose the headphone jack but do not remove the gasket from the cabinet. Insert a set of stereo headphones, not included, into the headphone jack. The built in speaker is automatically shut off when headphones are connected. Note: When using headphones reduce the volume to a low level before you put the headphones on. Then put the headphones on and gradually increase the volume to a comfortable listening level. After disconnecting the headphones be sure to re-seal the headphone jack with the silicon rubber gasket to prevent water or moisture from entering the cabinet. REPLACING THE BATTERIES Whenthesoundoutputbecomes weak ordistortedit’s timetoreplacethe batteries. Always useawell-knownbrandofalkalinebatteries andreplaceall8batteriesatthe same time. Do not mix old and new batteries, and do not mix different types of batteries such as alkaline and heavy-duty carbon-zinc batteries together. If the unit will not be used for a long period of time (30 days or longer) it’s a good idea to remove the batteries to prevent possible damage to the unit from battery leakage or corrosion. BATTERY PRECAUTIONS Follow these precautions when using batteries in this device: 1. Use only the size and type of batteries specified. 2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage tothe device. 3. Donotmixdifferent typesof batteriestogether(e.g.Alkalineand Carbon-Zinc)oroldbatteries with fresh ones. 4. Ifthedeviceisnottobeusedforalongperiodoftime,removethebatteriestopreventdamage or injury from possible battery leakage. 5. Do not try to recharge batteries not intendedto be recharged; theycan overheat and rupture. (Followbatterymanufacturer’sdirections.) 12 SR5999_ib111902.p65 12 19/11/2002, 10:18 CARE AND MAINTENANCE There areno user serviceable parts insidethe unit.Do notattemptan...