Votes - 2, Average rating: 5
(
)
)
|
manual abstract
example of a through mount setup. another option for mounting is a "direct Mount" where the machine is simply secured to the workbench with a lag screw. .................................................................................. Figure 9.. example of a direct mount setup. Creating Bends 1.. lift the clamp cam shaft to release the clamp die. Rotate the clamp die as necessary to accommodate the thickness of your work- piece, then slide the clamp cam shaft back into the base (Figures 10 & 11). Cam Shaft die Figure 10.. Lifting clamp cam shaft and die. Figure 11.. Clamp die positions. -4 T10050 Right angle iron Bender 2.. place the workpiece into the clamp and adjust the workpiece position as needed. Rotate the clamp cam shaft to clamp the workpiece (Figure 12). Figure 12.. Clamping workpiece. —if the clamp die does not move far enough to fully clamp the workpiece, repeat Steps 1 & 2. 3.. adjust the bending plate to support the work- piece while bending (Figure 13). .... Figure 13.. Tightening bending plate. NOTICE Use the machine only as it is intended to be used.. Adding cheater bars or other methods of increasing leverage may damage the machine and will void the warranty.. 4.. use the handle to bend the workpiece to the desired angle (Figure 14). Figure 14.. Bending workpiece. 5.. loosen the bending plate and clamp cam shaft to release the workpiece (Figure 15). ...... Figure 15.. Releasing workpiece. -5 T10050 Right angle iron Bender 2.. Bend the workpiece to the desired angle, Repetitive Bends then slide the angle stop against the bender base. Turn the angle stop to lock it in position (Figure 17). To ensure consistent and accurate bends when performing multiple, identical operations, use the work stop and angle stop. To use the work stop and angle stop: 1.. place the workpiece in the machine as needed, then slide the work stop against the end of the workpiece. Tighten the work stop knob (Figure 16). .................................... Figure 16.. Using work stop. .............................................. Figure 17.. Using angle stop. 3..With each new workpiece, place the work- piece against the work stop, clamp it, then bend it until the moving bender base contacts the angle stop. -6 T10050 Right angle iron Bender parts Breakdown & List ...................................................................................................... REF PART # DESCRIPTION REF PART # DESCRIPTION 1 PT10050001 BODY 2 PT10050002 CRANK 3 PT10050003 HANDLE 4 PT10050004 STATIONARY JAW 5 PT10050005 BENDING PLATE 6 PT10050006 BENDING PLATE KNOB 7 PT10050007 BENDING PLATE LEADSCREW 8 PT10050008 CLAMP DIE 9 PT10050009 CLAMP CAM SHAFT 12 PT10050012 COVER PLATE 13 PT10050013 END PLATE 14 PT10050014 ANGLE STOP 14-1 PSN05M SQUARE NUT M12-1.75 15 PT10050015 WORK STOP 16 PT10050016 WORK STOP ROD 17 PSW03-1 KNOB M10-1.5 x 35 18 PT10050018 PLASTIC GRIP 19 PB31M HEX BOLT M10-1.5 X 40 19-1 PW04M FLAT WASHER 10MM 20 PSB14M CAP SCREW M8-1.25 X 20 21 PRP08M ROLL PIN ...
Other models in this manual:Blenders - T10050 (1.69 mb)
Blenders - T10050 (1.69 mb)
Blenders - T10050 (1.69 mb)