Votes - 5, Average rating: 4
(
)
)
|
manual abstract
To protect against electrical shock, do not immerse cord, plug, blender unit, or motor unit in water or other liquid. 2. Close supervision is necessary when any appliance is used by or near children. 3. Unplug from outlet when not in use, before putting on or taking off parts, and before cleaning. 4. Make sure the blender is in the OFF position (O) before unplugging or plugging into any electrical outlet. 5. Avoid contacting moving parts. 6. Do not operate this appliance with a damaged cord or plug, or after the appliance malfunctions, or has been dropped or damaged in any manner. Return the Blender to the retail location where it was purchased for examination, repair, or adjustment. 7. Use this appliance only for its intended use as described in this manual.The use of attachments, including canning jars, is not recommended by Philips Electronics North America Corporation, as they may cause a risk of injury to persons. 8. Do not use outdoors or operate where oxygen is being administered or in the presence of explosive and/or flammable fumes. 9. Do not let cord hang over edge of table or counter, or touch hot surfaces, including the stove. 10. This appliance is intended for household use ONLY; it is not for commercial or industrial use. 11. Any service of the Blender should be performed by the retail location where it was purchased. 12. To disconnect, press the "O" button to "0FF" position, then remove plug from electrical outlet. Remove plug by gripping the plug body and pulling it from the outlet. Never yank or twist the cord to unplug. 13. Make sure the motor and the blades completely stop turning before putting on or taking off parts. 14. Keep hands, hair, and clothing, as well as spatulas and other utensils out of blender jar and away from sharp blades while blending to prevent the possibility of severe injury to persons and/or damage to the Blender. If scraping, folding, etc., is necessary, Blender must be turned off and unplugged, and only use a rubber spatula. 15. Blades are sharp. Handle carefully and with caution. 16. To reduce risk of injury to persons, never place mixing blades on base without blender jar properly attached. 17. Screw on blender jar bottom firmly. Injury can result if moving blades become exposed. 18 Always operate Blender with lid in place and in "closed" position. 19. Always hold blender jar while processing. If the jar should turn when the motor is switched "ON", switch Blender "OFF" by pressing "O" button immediately and tighten blender jar in threaded container bottom. 20. Do not fill the blender jar with ingredients hotter than 140.F/60.C. 21. To avoid spillage, do not fill blender jar above the maximum level indication (5 cups/1.25 liters), particularly when blending liquids. Always insert stopper into the lid before you begin processing. 22. Never let the appliance run unattended. 23. When blending hot liquids, remove the stopper from the two-piece cover. DO NOT fill beyond 5 cups/1.25 liters level. Always begin processing at the lowest speed setting. Keep hands and other exposed skin away from the cover opening to prevent possible burns. 24. The blender jar is made of glass and therefore breakable. Do not drop the glass container on a floor or hard surface. Avoid extreme temperatures. If the glass container is very cold, rinse it well with lukewarm water before pouring in hot liquid. 25. If the glass jar cracks, discontinue use. 26. Always make sure that the rubber sealing ring is in the correct position before you use the Blender. 27. The blender base is intended for use only with this blender jar. Do not substitute any other blender jar. 28. This Blender has been equipped with an automatic safety cut-out which cuts off the power supply in case of an overload. In this case, the pin at the bottom of the Blender will pop out. If you push the pin back into the appliance, it will start again. SAVE THESE INSTRUCTIONS SPECIAL INSTRUCTIONS This Blender has a short cord to reduce the hazards of becoming entangled in or tripping over a longer cord. An extension cord may be used if the rating is equal to or greater than the rating of the Blender. Use an extension cord rated 13 amperes or greater. Care must be taken to arrange extension cord so that it will not drape over countertop or tabletop where it can be pulled on by children or tripped over unintentionally. Operating the Blender and another appliance at the same time from the same electrical circuit could cause an electrical overload condition, which would blow the fuse or trip the circuit breaker. SPECIAL POLARIZED PLUG INSTRUCTIONS This Philips Blender has a polarized plug for an added safety feature (one blade is wider than the other). To reduce the risk of electrical shock: • Plug will fit into polarized outlet only one way. • If plug does not properly fit outlet at first, reverse it. • If plug still does not fit, contact a qualified electrician. DO NOT ATTEMPT TO DEFEAT THIS SAFETY FEATURE Table of Contents Features 2 I...