Votes - 4, Average rating: 4 ( )

Manafacture: Audiovox File size: 546.69 kb File name: Language of manual:

Cut only where indicated. Make sure that the 7" cut is centered left to right in vehicle. See Figure 2. DO NOT OVERCUT HEADLINER. 3. Scribe a center line on the sheet metal roof of the vehicle in front and rear of openings in headliner. This will be used for bracket alignment. See Figure 2. FIGURE 2 FIGURE 3 4. Install mounting bracket (item 6 pg. 2) with the bent edges upward. Slide bracket rearward until rear tabs engage rear O.E. roof brace. Align notches in bracket with center lines scribed on roof. See Fig. 3 and Fig. 4. 5. Secure front of bracket to front roof brace using (2) two # 10 X 1/2" screws (item 1 pg 2). 3 6. Make sure tabs on mounting bracket engage O.E. roof brace and notch aligns with center line. See Figure 4. FIGURE 4 7. Construct a jumper harness that will connect the vehicle’s dome light wires to the lights in video system. Connect the white wire to the O.E. pink wire. Connect the black wire to the O.E. yellow wire. See Figure 5. 8. Using a test light, test function of lights. 9. Install O.E. dome light in original manner. FIGURE 5 4 10. Install and route all video and audio cables, and any other added component requirements to their respective places in the vehicle. Refer to component installation instructions for wiring diagrams. The suggested routing of the video system cable is as follows: Above the headliner from video system to B-pillar. Down the B-pillar to the floor. Route the power lead to an accessory controlled source. Connect the ground lead to the vehicle chassis. Route the remaining wiring (RCA plugs, Remote Sensor extension, etc.) to the VCP location. See Figure 6. Connect per instructions included with the video system. If video system if to be used as a television, install an appropriate antenna per instructions included with the antenna. FIGURE 6 II. INSTALLATION OF CONSOLE IF SPEAKER UPGRADE KIT WAS PURCHASED, INSTALL PER INSTRUCTIONS PROVIDED. 11. Raise console (item 8 pg.2) into approximate position against headliner. Loosely install using (2) two 6-32 x 3/4" screws (item 2 pg. 2) through the smaller holes in bracket on console into threaded clips on front mounting bracket. See Figure 7. 12. Using a scribe or similar tool, align hole in rear of console with slot in rear mounting bracket. Loosely secure rear of console using (1) one # 8 x 1 1/2" screw (item 4 pg. 2). Make sure console alignment is straight then tighten (2) two 6-32 screws previously installed. See Figure 7. FIGURE 7 5 13. Release video screen from locked position. Lower video screen to viewing position for access to mounting location in top of video system housing. 14. Raise video system into approximate position and connect all wiring to components. Connect wiring and cabling to video system per instruction included with video system. 15. Check function of all component and lights. See operating instruction for video system operations check. For further assistance, refer to the video system manual for the technical support phone number l...

Download now

Please, enter two numbers from picture: