Votes - 2, Average rating: 3.5
(
)
)
|
manual abstract
Programming instructions are described and illustrated below. The additional push buttons can also activate other garage door openers and/or light controls. (Instructions for programming light products are included with those accessories.) KG 1 3 9 7 5 KG 1 3 9 7 5 1 2 OR LOCK LIGHT KG KG 1 3 9 7 5 1 3 9 7 5 1 2 3 Remote Coding Instructions 1. Press and release the “learn” button on the motor unit. The learn indicator light will glow steadily for 30 seconds. 2. Within 30 seconds, press and hold the button on the hand-held remote. 3. Release the button when the motor unit light blinks. It has learned the code. If light bulbs are not installed, two clicks will be heard. To Erase All Codes From Motor Unit Memory To deactivate any unwanted remote, first erase all codes. Press and hold the “learn” button on motor unit until the “learn” indicator light goes out (approximately 6 seconds). All previous codes are now erased. Reprogram each remote or keyless entry you wish to use. To order replacement parts call... 1-800-4-MY-HOME® (1-800-469-4663) The Remote Control Batteries The lithium battery should produce power for up to 5 years. To replace battery, use the visor clip or screwdriver blade to pry open the case as shown. Insert battery matching polarity instructions inside the remote cover or on the printed cirucuit board. Dispose of old battery properly. Replacement parts: Security.® 3-Function remote control housing only (No circuit board) . . . . . . . . . . . . . .41A5032 Security.® Compact 3-Function remote control housing only (No circuit board) . . . . . . . . . . . . . .41A5062 3V2032 Lithium battery: (Models 139.53681B and 139.53680) . . . . . . . . . . .10A20 3V2016 Lithium battery: (Model 139.53681) . . . . . .10A19 Visor clip: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .29B134 3-FUNCTION COMPACT Twist here to open Open this end first to avoid cracking housing To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door: • ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote control transmitters. • Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel. • ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to cross path of moving gate or door. WARNING CAUTION USER INSTRUCTIONS To Control the Motor Unit Lights (Premium Consoles Only) With Security.® transmitters, a remote push button can be programmed to operate the motor unit lights without opening the door. 1. With the door closed, press and hold the remote button that you want to control the light. 2. Press and hold the Light button on the door control. 3. Press and hold the Lock button on the door control. 4. After the motor unit lights flash, release all buttons. Test by pressing the remote push button. The motor unit lights should turn on or off but the door should not move. To prevent possible SERIOUS INJURY or DEATH: • NEVER allow small children near batteries. • If battery is swallowed, immediately notify doctor. WARNING CAUTION NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 114A2110D © 2006, Sears, Roebuck and Co./ ® Registered Trademark / ™ Trademark / SM Service Mark of Sears, Roebuck and Co. ® Marca Registrada / ™Marca de Fabrica / SM Marca de Servicio de Sears, Roebuck and Co. Modelo 139.53681B Security.® Control Remoto de 3 funciones Modelo 139.53680 Security.® Control Remoto Compacto de 3 funciones El control remoto Security.® solo funciona con los abridores de puertas de garajes y controles de iluminacion que tienen un boton de “Aprender” (Learn) anaranjado y una luz indicadora amarilla. Las instrucciones de programacion se describen e ilustran abajo. Los botones adicionales pueden activar tambien otros abridores de puertas de garaje y/o controles de luz. (Se incluyen con esos accesorios instrucciones para programar productos de iluminacion.) KG 1 3 9 7 5 KG 1 3 9 7 5 1 2 O LOCK LIGHT KG KG 1 3 9 7 5 1 3 9 7 5 1 2 3 Instrucciones Codi...
Other models in this manual:Safety Gate - SECURITY 139.53681B (242.44 kb)