Votes - 3, Average rating: 4.3
(
)
)
|
manual abstract
No part of this documentation may be reproduced in any form, without prior written consent of Essex Electronics, Inc. Essex Electronics shall not be liable for errors contained in this manual. The information in this document is subject to change without notice. Essex Electronics, Inc. reserves the right to modify this documentation and to make improvements or changes to the product(s) contained in this documentation at any time. Document Information IOMKE265.0406.Rev D Installation/Operations Manual for KE-265, April 2006 Revision D This documentation is applicable to the KE-265 with Rev. C on the date code label. (Located on the control module circuit board). This documentation is also applicable to prior revisions except where noted. Trademarks Keyless Entry ® is a registered trademark of Essex Electronics, Inc. Lexan ® is a registered trademark of General Electric Co., USA. Contact Information Essex Electronics, Incorporated 1130 Mark Avenue Carpinteria, CA 93013 (805) 684-7601 FAX (805) 684-0232 Website: keyless.comGeneral email: essex@Technical Support Copyright © 2001-2006 Table of Contents INTRODUCTION....................................................................................... 2 OVERVIEW.............................................................................................. 2SYSTEMSPECIFICATIONS........................................................................ 2INPUT REQUIREMENTS............................................................................. 3OUTPUT CAPABILITIES............................................................................. 3KEYPAD OPTIONS.................................................................................... 4 PREPARING FOR INSTALLATION......................................................... 5 SYSTEMCOMPONENTS............................................................................ 5 THE INSTALLATION PROCEDURE........................................................ 6 REQUIRED TOOLS................................................................................... 6PREPARE THE KEYPAD FOR INSTALLATION................................................ 6INSTALL THE WIRING CABLE..................................................................... 8MOUNT THE KEYPAD............................................................................... 8PREPARE THE DOOR FOR THE ELECTRIC STRIKE...................................... 8INSTALLING THE CONTROL MODULE......................................................... 8CONNECTING THE LOCKING DEVICE......................................................... 9BATTERYBACKUP................................................................................... 9 SYSTEM HARDWARE SETUP.............................................................. 10 REMOTE BY-PASS................................................................................. 10ANTI-TAILGATING.................................................................................. 10SETTING RELAYOPTIONS...................................................................... 10TAMPER ALARM LOCKOUT..................................................................... 13 SYSTEM PROGRAMMING.................................................................... 14 OVERVIEW OFSYSTEMCODEPROGRAMMING......................................... 14OVERVIEW OF THE MASTER CODE......................................................... 14PROGRAMMING THEMASTER CODE....................................................... 15OVERVIEW OFUSER CODES.................................................................. 15PROGRAMMING USER CODES................................................................ 16PROGRAMMING DOOR OPEN TIME......................................................... 16 TROUBLESHOOTING............................................................................ 18 REPAIRS AND WARRANTY.................................................................. 20 REPAIR POLICY..................................................................................... 20WARRANTY........................................................................................... 21 APPENDIX A – CIRCUIT 23 APPENDIX B - TYPICAL 24 NOTES.................................................................................................... 25 1 Introduction Overview The KE-265 is an easy to program, easy to use, stand-alone Keyless Entry ® system with features suitable for basic access control requirements. Providing either a voltage output or dry contact closure, the KE-265 is designed to control any fail-safe or fail-secure electric locking device. The KE-265 features one master code and five user codes. Two relay outputs are available to provide a variety of access control configurations including single door operation with an auxiliary output for a CCTV/Light Controller, a Gate/Garage Door controller or Doorbell activation or the KE-265 can be configured for two door operation. System Specification...