Votes - 1, Average rating: 4
(
)
)
|
Other manuals for this model:
manual abstract
Cautions
Specifications
Batteries
Frequency range
FM:
87.5 to 108.0 MHz (50 kHz step)
• If the unit is not used for a long period of time, remove the
AM:
522 to 1629 kHz (9 kHz step)
batteries to prevent potential damage due to possible battery
Sampling frequency
44.1 kHz
leakage.
Decoding
16 bit linear
• Do not heat, disassemble, or allow contact with flame or water.
Beam source
Semiconductor laser (wavelength 780 nm)
• Do not peel off the covering and do not use if the covering has been
(NORSK)
peeled off.
Bølgelengde
780 nm
Laserstyrke
Ingen farlig stråling sendes ut
Battery mishandling can cause electrolyte leakage which can damage
(med sikkerhets-beskyttelse)
items the fluid contacts and may cause a fire.
Number of channels
2 channel, stereo
If electrolyte leaks from the batteries, consult your dealer.
Wow and flutter
Less than possible measurement data
Wash thoroughly with water if electrolyte comes in contact with any part of
D/A converter
1 bit DAC
your body.
Speakers
4.5 cm, 6 Ω x 2
Power requirement
AC 230 V, 50 Hz
CDs
Power consumption: 11 W
Memory back-up
9 V (One 6F22/6LR61, 006P battery)
• Do not use irregularly shaped CDs.
Dimensions (W x H x D) 266 x 149 x 137 mm
• Do not use non-specification discs.
Mass
1.43 kg without battery
• Do not use CDs printed with label printers available on the market.
• Do not use CDs with labels and stickers that are coming off or with
Power consumption in standby mode: 2.3 W
adhesive exuding from under labels and stickers.
Note on CD-R/RW
This unit can play CD-R and CD-RW recorded with CD-DA. Use an audio
Note
recording disc and finalize* it when you finish recording. The unit may not
Specifications are subject to change without notice.
be able to play some discs due to the condition of the recording.
Mass and dimensions are approximate.
* A process that enables CD-R/CD-RW players to play audio CD-R and
CD-RW.
Maintenance
To clean this unit, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean this unit.
Troubleshooting guide
• Before using chemically treated cloth, read the instructions that came
with the cloth carefully.
Before requesting service, make the below checks. If you are in doubt
about some of the check points, or if the remedies indicated in the chart
do not solve the problem, consult your dealer for instructions.
The clock shows
• Set the clock.
“-:--”.
There is a lot of
• Keep away from mobile phones,
noise.
televisions, and other tuners.
• Extend and change the direction of the
antenna.
The alarm doesn’t
• Ensure the alarm’s indicator is on (“ALARM 1”,
sound at the set time.
“ALARM 2”, or “ALARM 3”).
The memory has
• Reset the items into the memory.
been cleared.
• Insert a battery to preserve the memory
contents.
“no dISC” appears.
• You haven’t inserted a CD.
Play doesn’t start or
• Clean the CD.
display is incorrect.
• Clean the lens with a blower (SZZP1038C
recommended). If the lens gets marked
with fingerprints, gently wipe them off with
a cotton swab.
• Wait an hour for condensation to dry, then
try again.
• Make sure the label is facing out.
• Replace the CD if it is scratched, warped,
or irregularly shaped.
The CD or radio
• These displays disappear after a few
display disappears.
seconds. To show them again, press
[DISPLAY, –DIMMER].
607
T7
Q
R
6
6
...