Votes - 0, Average rating: 0
(
)
)
|
Other manuals for this model:
manual abstract
The Auto Off function does not operate.
CD playback
The unit is turned on. The Auto Off function activates
The disc cannot be loaded.
after turning off the unit.
• Another disc is already loaded.
t Turn off the unit.
• The disc has been forcibly inserted upside down or in
the wrong way.
Radio reception
The disc does not playback.
The stations cannot be received.
• Defective or dirty disc.
The sound is hampered by noises.
• The CD-Rs/CD-RWs are not for audio use (page 20).
• The connection is not correct.
MP3/WMA/AAC files cannot be played back.
t Connect a power antenna (aerial) control lead
The disc is incompatible with the MP3/WMA/AAC
(blue) or accessory power supply lead (red) to the
format and version. For details on playable discs and
power supply lead of a car’s antenna (aerial)
formats, visit the support site.
booster (only when your car has built-in FM/
MP3/WMA/AAC files take longer to play back
MW/LW antenna (aerial) in the rear/side glass).
than others.
t Check the connection of the car antenna (aerial).
The following discs take a longer time to start
t If the auto antenna (aerial) will not go up, check
playback.
the connection of the power antenna (aerial)
– a disc recorded with a complicated tree structure.
control lead.
– a disc recorded in Multi Session.
Preset tuning is not possible.
– a disc to which data can be added.
• Store the correct frequency in the memory.
The display items do not scroll.
• The broadcast signal is too weak.
• For discs with very many characters, those may not
Automatic tuning is not possible.
scroll.
• Setting of the local seek mode is not correct.
• “A.SCRL” is set to “OFF.”
t Tuning stops too frequently:
t Set “A.SCRL-ON” (page 18).
Set “LOCAL-ON” (page 18).
t Press and hold (DSPL) (SCRL).
t Tuning does not stop at a station:
The sound skips.
Set “LOCAL-OFF” (page 18).
• Installation is not correct.
• The broadcast signal is too weak.
t Install the unit at an angle of less than 45° in a
t Perform manual tuning.
sturdy part of the car.
During FM reception, the “ST” indication
• Defective or dirty disc.
flashes.
The operation buttons do not function.
• Tune in the frequency accurately.
The disc will not eject.
• The broadcast signal is too weak.
Press the RESET button (page 6).
t Set “MONO-ON” (page 18).
An FM program broadcast in stereo is heard in
monaural.
USB playback
The unit is in monaural reception mode.
You cannot play back items via a USB hub.
t Set “MONO-OFF” (page 18).
This unit cannot recognize USB devices via a USB
hub.
RDS
Cannot play back items.
A USB device does not work.
The SEEK starts after a few seconds of
t Reconnect it.
listening.
The USB device takes longer to play back.
The station is non-TP or has weak signal.
t
The USB device contains files with a complicated tree
Deactivate TA (page 12).
structure.
No traffic announcements.
A beep sounds.
• Activate TA (page 12).
During playback, the USB device has been
• The station does not broadcast any traffic
disconnected.
announcements despite being TP.
t Tune in another station.
t Before disconnecting a USB device, make sure to
stop playback first for data protection.
PTY displays “- - - - - - - -.”
The sound is intermittent.
• The current station is not an RDS station.
The sound may be intermittent at a high-bit-rate of
• RDS data has not been received.
more than 320 kbps.
• The station does not specify the program type.
24
...