|
Other manuals for this model:
manual abstract
300 mA, 12 V DC). If the vehicle is equipped with a glass antenna, connect it to the antenna booster power supply terminal. • Never connect blue/white cable to external power amp’s power terminal. Also, never connect it to the power terminal of the auto antenna. Otherwise, battery drain or malfunction may result. • Black cable is ground. This cable and other product’s ground cable (especially, high-current products such as power amp) must be wired separately. Otherwise, fire or malfunction may result if they are accidentally detached. * Cord function may differ according to the product, even if cord color is the same. When connecting this system, be sure to check all manuals and connect cords correctly. ENGLISH Connection Diagram 1. Rear output 2. This product 3. Antenna jack 4. Fuse (10 A) 5. Wired remote input Hard-wired remote control adaptor can be connected (sold separately). 6. Note: Depending on the kind of vehicle, the function of 3* and 5* may be different. In this case, be sure to connect 2* to 5* and 4* to 3*. 7. Connect leads of the same color to each other. 8. Cap (1*) Do not remove cap if this terminal is not in use. 9. Yellow (3*) Back-up (or accessory) 10. Yellow (2*) Connect to the constant 12 V supply terminal. 11. Red (5*) Accessory (or back-up) 12. Red (4*) Connect to terminal controlled by ignition swich (12 V DC). 13. Black (chassis ground) Connect to a clean, paint-free metal location. 14. ISO connector Note: In some vehicles, the ISO connector may be divided into two. In this case, be sure to connect to both connectors. 15. Speaker leads White: Front left © White/black: Front left © Gray: Front right © Gray/black: Front right © Green: Rear left © Green/black: Rear left © Violet: Rear right © Violet/black: Rear right © 16. Connect with RCA cables (sold separately) 17. Power amp (sold separately) 18. Blue/white Connect to system control terminal of the power amp (max. 300 mA 12 V DC). 19. System remote control 20. Blue/white (7*) Connect to auto-antenna relay control terminal (max. 300 mA 12 V DC). 21. Blue/white (6*) 22.The pin position of the ISO connector will differ depends on the type of vehicle. Connect 6* and 7* when Pin 5 is an antenna control type. In another type of vehicle, never connect 6* and 7*. 23. Left 24. Right 25. Rear Speaker 26. Perform these connections when using the optional amplifier. 27. Yellow/black If you use an equipment with Mute function, wire this lead to the Audio Mute lead on that equipment. If not, keep the Audio Mute lead free of any connections. Conexión de las unidades Nota: • Cuando se instale esta unidad en un vehículo sin la posición ACC (accesorio) en el interruptor de encendido, se debe conectar el cable rojo al terminal que puede detectar la operación de la llave de encendido. De lo contrario, la batería puede descargarse. Posición ACC Sin posición ACC • El uso de esta unidad en condiciones diferentes de las siguientes podría...
Other models in this manual:Car Receivers - DEH-2900MP (331.75 kb)
Car Receivers - DEH-2920MP (331.75 kb)
Car Receivers - DEH-3900MP (331.75 kb)