2 Adjust the front/back and left/right volume around the touched area. 3 Adjusts the right and left volume balance. 4 Adjusts the front and rear volume balance.* 5 Turns the Loudness control function On or Off.* If turned "ON", high and low tones are automatically enhanced during low volume. 6 Displays the present source information. The stream (Dolby Digital, dts, Linear PCM, MPEG, MP3, WMA or AAC) is displayed. 1 Switches to the selected Audio Control screen. KVT-524DVD/KVT-554DVD/KVT-54DVDR 7 8 9 7 Returns to the "Audio Control 1" screen. 8 Adjusts the subwoofer volume.* 9 Adjusts the volume of the present source based on the difference level of original volume. . • * Settable Only when zone function is set to Off. See (page 82). • If you have increased the volume first, then reduced the volume using the "Vol. Offset", the sound generated if you suddenly switch to another source may be extremely loud. Equalizer Control You can set up the equalizer. 1 Display Equalizer Control Touch in the "Audio Control Menu" screen (page 80). 2 Display the Equalizer screen 2 3 1 1 Selects an equalizer curve type. You can select any of the following equalizer curves. • "Natural" • "Rock" • "Pops" • "Easy" • "Top40" • "Jazz" • "User" . • "User" can be selected after tone adjustment is carried out. See (page 82). 2 Selects items to be adjusted for tone curve setup. If turned "OFF", only Level can be setup for tone curves. 3 Displays the Tone curve setup screen. (page 82) English Audio Control Tone Setup You can set a Tone curve. 1 Display the Tone screen See (page 81). 2 Set the Tone 1 2 3 4 5 6 7 8 9 1 Tone curve becomes flat. 2 Bass adjustment items are displayed. 3 Middle adjustment items are displayed. 4 Treble adjustment items are displayed. 5 Sets the Center frequency. 6 Sets the level. 7 Sets the Q factor. (Only Bass and Middle can be set) 8 Bass DC Extend settings (Only when Bass is selected) If turned "ON", it extends the bass center frequency to the low register by approximately 20%. 9 Returns to the "Equalizer" screen. Zone Control You can set the front and rear audio source. 1 Display Zone Control Touch in the "Audio Control Menu" screen (page 80). 1 1Displays the current source. 2 Set the Zone Control 2 3 3 4 2 Turns the Zone Function (that sets different source sounds for front and rear speakers) On or Off. 3 Sets the front and rear audio source separately. (This button appears when the Zone function is On.) . • When the rear speaker sound is switched, the audio source that is output at the AV OUTPUT terminal is also switched to the same source. 4 Adjusts the volume of the rear channel. (This button appears when the Zone function is On.) KVT-524DVD/KVT-554DVD/KVT-54DVDR . • There are following limitations when zone function is set to "On". -There is no output from the subwoofer. -
)
