Votes - 2, Average rating: 4
(
)
)
|
manual abstract
The following table describes the differences between two models. Model Weather Band CQ-210ÛEU Yes CQ-2000EU No Find the model number and serial number on either the back or bottom of the unit. Please record them in the space below and retain this booklet as a permanent record of your purchase to aid in identification in case of theft. MODEL NUMBERCQ-2100EU/2000EU SERIAL NUMBER DATE PURCHASED FROM Use This Equipment Safely Contents ...............................................Page 2 Cl Power and Sound Controls..................................................... How to adjust the volume, balance, and tone for best listening Q Radio Basics.................................................................................................5 Manual and automatic tuning, band selection, preset stations, weather band □ Cassette Tape Player Basics............................ How to load, wind, play, and eject a cassette tape a a I [o ©! / —\ A ■\ I □ Clock Basics.............................................. Setting the time, selecting the clock display 9: B nn uu □ Installation Guide.......................................................................................10 Step-by-step procedures, anti-theft system, electrical connections □ Troubleshooting.........................................................................................17 Troubleshooting tips, where to get service help (I (I (I (/W QQQQQ Specifications..................................................................................................19 3 Power and Sound Controls Power Turn the ignition key on. Turn the knob clockwise to switch on the power. When turn off the power, clock will also show on the display. Volume Turn the knob clockwise to increase volume, and counterclockwise to decrease volume. Balance Keep pulling the knob and turn it to the left or right to shift the sound volume to the left or right speakers. Bass and Treble Bass control : Turn the knob to adjust bass response. Treble control: Pull and lock the knob and turn to adjust treble response. After adjusting, press the knob in. Fader Turn to the left or right to shift the sound volume to the front or rear speakers. 4 Radio Basics Selecting a Band • It can not be changed to radio mode while tape playing. If you want to change radio mode, eject the tape. • Press BAND to select the bands in the following order. FM1 =► FM2 =S> FM3 => AM FM1 => FM2 =* AM =» WB{Weather Band) t_I t_* (Only for CQ-2000EU) (Only for CQ-2100EU) “ ST" indicator lights if the station is broadcasting in stereo. If»3 '“I ffiituC. « Manual Tuning Press U/\TUNE” or “VTUNE” to move to a higher or lower frequency. Seek Tuning Press and hold “ATUNE" or “VTUNE” for more than a half second, then release. The radio automatically stops on the next station. Scan Tuning • Press the knob to scan the next stations for about 5 seconds sequentially upward. • Press the knob again to cancel. To reduce interference during FM broadcasts Press MONO/ST for monaural reception in case a lot of interference is present in an FM stereo signal or to improve the listening quality of weak FM broadcasts. 5 Radio Basics continued Preset Station Setting Up to 24 stations can be preset in the station memory as follows; FM1 FM2 FM3 AM 6 stations 6 stations 6 stations 6 stations FM1 FM2 AM 6 stations 6 stations 6 stations (Only for CG-2000EU) (Only for CQ-2100EU) Manual Station Preset (D Press BAND to select a desired band. (2) Use manual or seek tuning to find a station that you want to program into memory. (D Press and hold one of the station selector buttons 1 through 6 until the display blinks. The memory is now set for that button on the band you have selected. Repeat the process to set other stations for the FM1 to AM bands. Siga!-» -BUTTON NUMBER Note: You can change the memory setting by repeating the above procedure. Tuning in a Preset Station Press any of the buttons 1 through 6 to tune in the station preset by the above steps © to (3). Auto Station Preset Select a band and press and hold BAND for more than 2 seconds. • The 6 strongest available stations will be automatically set in memory on preset buttons'1 through 6. • Once set, the preset stations are sequentially scanned for 5 seconds. ■ Press the appropriate preset button for the station you want to hear. CAUTION: For safety reasons, do not attempt to program while driving. Continued (Only for CQ-2100EU) Note: The weather band (CH1-6) has been preset in advance. CH7 is selected by pressing “ATUNE" or “VTUNE”. Weather Band Stations National Weather Radio Broadcasts from over 380 locations throughout the U.S. on seven VHF/FM frequencies. Tune to weather band to receive continuous weather information 24 hours a day on one of the following frequencies. 1. 162.550 MHz 2. 162.400MHZ 3. 162.475 MHz 4. 162.425 MHz 5. 162.450 MHz 6. 162.500 MHz 7. 162.525 MHz Occasional...