Votes - 0, Average rating: 0
(
)
)
|
Photos and specs Sony SA-VE345 |
Other manuals for this model:
manual abstract
See the table below for the proper settings. For details on the setting procedure, refer to the manual that was provided with your amplifier. Speaker setup For Set to Front speakers SMALL Center speaker SMALL Surround speakers SMALL Subwoofer ON (or YES) If you use the amplifier with adjustable crossover frequency, it is recommended to select 150 Hz (or close to this figure) as the crossover frequency for your front, center, and surround speakers. ** “DTS” and “DTS Digital Surround” are registered trademarks of Digital Theater Systems, Inc. Listening to the sound (H) First, turn down the volume on the amplifier. The volume should be set to minimum before you begin playing the program source. 1 Turn on the amplifier and select the program source. 2 Press POWER on the subwoofer. The ON/STANDBY indicator on the subwoofer lights up green. 3 Play the program source. Power turns on and off automatically — Auto power on/off function (I) When the subwoofer is on (i.e, the ON/STANDBY indicator lights up green) and there is no signal input for a few minutes, the ON/STANDBY indicator changes to red and the subwoofer enters power saving mode. While in this mode a signal is input to the subwoofer, the subwoofer automatically turns on (auto power on/off function). To turn this feature off, slide the POWER SAVE switch on the rear panel to OFF. Notes •If you turn down the volume level of the amplifier too low, the auto power on/off function may activate, causing the subwoofer to enter power saving mode. •Circuit protection is contained in the satellite and center speakers. If the speakers are overdriven for certain period, the circuit protection will automatically reduce •Make sure all the connections have been correctly made. •Make sure the volume on the amplifier has been turned up properly. •Make sure the program source selector on the amplifier is set to the proper source. •Check if headphones are connected. If they are, disconnect them. There is distortion in the subwoofer sound output. •Check if any sound-enhancing functions have been activated on the amplifier. If they have, turn them off. There is hum or noise in the speaker output. •Make sure all the connections have been correctly made. •Make sure none of the audio components are positioned too close to the TV set. The sound has suddenly stopped. •Make sure all the connections have been correctly made. Contact between bare speaker wires at the speaker terminals may cause a short-circuit. Specifications SA-VE345 SS-V345 (front and surround speakers) Speaker system Full range magnetically shielded Speaker units 5.5 . 11 cm, cone type Enclosure type Bass reflex Rated impedance 8 ohms Power handling capacity Maximum input power: 110 watts Sensitivity level 85 dB (1 W, 1 m) Frequency range 120 Hz - 20,000 Hz Dimensions (w/h/d) Approx. 85 . 152 . 112mm, including front grille Mass Approx. 850 g each SS-CN345 (center speaker) Speaker system Full range magnetically shielded Speaker units 5.5 . 11 cm, cone type Enclosure type Bass reflex Rated impedance 8 ohms Power handling capacity Maximum input power: 110 watts Sensitivity level 85 dB (1 W, 1 m) Frequency range 90 Hz - 20,000 Hz Dimensions (w/h/d) Approx. 300 . 81 . 122 mm, including front grille Mass Approx. 1,100 g SA-WMS345 (subwoofer) Speaker system Active subwoofer, magnetically shielded Speaker unit Woofer: 20 cm, cone type Enclosure type Advanced SAW type Reproduction frequency range 26 Hz - 200 Hz Amplifier section Continuous RMS power output 110 W (8 ohms, 20 Hz 20 kHz, 0.8 % THD) Inputs LINE IN (input pin jack) General Power requirements 110 -120/220 - 240 V AC, 50/60 Hz Power consumptions 90 W 1 W (standby mode) Dimensions (w/h/d) Approx. 230 . 392 . 447 mm, including front grille Mass Approx. 13.2 kg Supplied accessories Foot pads (20) Audio connecting cord (1) Speaker connecting cords, 10 m (2) Speaker connecting cords, 3.5 m (3) Design and specifications are subject to change without notice. N’installez pas l’appareil dans un espace confine comme dans une bibliotheque ou un meuble encastre. ENERGY STAR® est une marque deposee aux Etats-Unis. En tant que partenaire d’ENERGY STAR®, Sony atteste que son produit repond aux recommandations d’ENERGY STAR® en matiere d’economie d’energie. A propos de ce manuel Le SA-VE345 est un ensemble d’enceintes 5.1 canaux compose de deux enceintes avant, deux enceintes arriere, une enceinte centrale et un caisson de grave. Il prend en charge les systemes Sony Digital Cinema Sound, Dolby* Pro Logic, et Dolby Digital etc. Il est par consequent reserve au visionnage de films. * « Dolby » et le symbole double D sont des marques de Dolby Laboratories. Precautions Securite • Ava...