Votes - 0, Average rating: 0
(
)
)
|
manual abstract
Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. Model No. Serial No. CAUTION Use of this appliance with some systems may present a shock or fire hazard. Do not use with any unit which have the following marking located near output. WARNING: HAZARDOUS ENERGY ! You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. (continued) A B Speaker cord Cordon de haut-parleur Amplifier Amplificateur Adaptor Adaptateur C 10m (30ft) CD player Lecteur CD D E LEVEL English (continued) NOTICE FOR THE CUSTOMERS IN CANADA CAUTION: TO PREVENT ELECTRIC SHOCK, DO NOT USE THIS POLARIZED AC PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. Precaution • The AC power cord must be changed only at a qualified service shop. • The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. • The nameplate is located on the bottom exterior. • Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. Unpacking • Input adaptor IAD-IF70 (1) • Speaker cords (2) Hookups 1 Connect the transmitter (supplied with the SA-IF70) to the TRANSMITTER jack on the input adaptor (A). 2 To use the wireless speakers as the rear speakers: Connect the INPUT B speaker terminal on the rear panel to the REAR SPEAKER terminal on your amplifier (B). To use the wireless speakers as the main speaker: Connect the INPUT A jack on the front panel to the PHONES OUT jack on the CD player/portable cassette player (C). 3 Connect the AC power cords of the INPUT ADAPTOR and WIRELESS SPEAKER to separate wall outlets (B, C). Note When you connect both inputs (INPUT A and INPUT B) to the different components, you can hear the sound from the component through INPUT A. If you want to hear the component connected to INPUT B, pull out the INPUT A cord. Operation 1 Place the speakers within the effective range. When using the wireless speakers as the rear speakers, refer the Operating instructions supplied with the SA-IF70. When using the speakers as the main speakers, place them within the effective range as shown the illustration (D). 2 Press POWER to turn on the adaptor. The indicator on the adaptor lights up green. When the sound is not heard Adjust the position, direction and angle of the transmitter so the wireless speakers are within the effective range. Adjusting the level You can also adjust the level using LEVEL on the front panel (E). You make use of the maximum level. Troubleshooting No bass sound is heard from the rear speakers. • Check that the speaker cords are connected properly (B). A very low level sound is heard. • You make use of the high level using LEVEL on the front panel. Specifications Power requirements The U. S. A. and Canada models: 120V AC, 60 Hz Other region models: 220 - 230V AC, 50/60 Hz Rated impedance INPUT A (1.55V/10 KW) INPUT B (13.77V/2 KW ) Power consumption 11 watts Dimentions(w/h/d) Approx. 85 . 70 . 140 mm (3 3/. 2 7/. 5 5/ inches) 8 88 Mass The U. S. A. and Canada models: 730 g (1 lb 10 oz) Other region models: 750 g ( 1 lb 11 oz) Supplied accessories Speaker cords (2) Design and specifications are subject to change without notice. Francais AVERTISSEMENT Pour prevenir tout risque d’incendie ou d’electrocution, gardez cet appareil a l’abri de la pluie et de l’humidite. Pour prevenir tout risque d’electrocution, abstenez-vous d’ouvrir le boitier. Confiez l’entretien de cet appareil exclusivement a un personnel qualifie. NOTICE POUR LES CLIENTS AU CANADA ATTENTION: POUR PREVENIR LES CHOCS ELECTRIQUES, NE PAS UTILISER CETTE FICHE POLARISEE AVEC UN PROLONGATEUR, UNE PRISE DE COURANT OU UNE AUTRE SORTIE DE COURANT, SAUF SI LES LAMES PEUVENT ETRE INSEREES A FOND SANS EN LAISSER AUCUNE PARTIE A DECOUVERT. Precautions • Le cordon d’alimentation (secteur) peut uniquement etre remplace dans un centre de service apres-vente agree. • L’appareil n’est pas deconnecte de la source d’alimentation (secteur) aussi longtemps qu’il reste branche sur la prise murale, meme si l’appareil proprement dit a ete mis hors tension. • La plaquette signaletique se trouve sur le dessous de l’appareil, a l’exterieur. • N’installez pas l’appareil dans un espace confine, comme une bibliotheque ou un meuble encastre. Deballage • Adaptateur d’entree IAD-IF70 (1) • Cordons de haut-parleur (2) Raccordement 1 Raccordez le transmetteur (fourni avec le SA-IF70) a la prise TRANSMITTER de l’adaptateur d’entree (A). 2 Pour utiliser les haut-parleurs sans fil comme haut-parleurs arriere : Raccordez la borne de haut-parleur INPUT B du panneau arriere a la borne REAR SPEAKER de votre amplificateur (B). Pour utiliser les haut-parleurs sans fil comme haut-parleurs principaux : Raccordez la prise INPUT A du panneau frontal a la pr...