Votes - 3, Average rating: 4
(
)
)
|
manual abstract
This speaker package consists of the component shown on the table below. NS-P9900 NS-C9900 Center speaker x 1 NS-E9900 Surround speaker x 2 PRECAUTIONS Read this before using the speakers. • To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. • Install the speaker in a cool, dry, clean place – away from windows, heat sources, sources of excessive vibration, dust, moisture and cold. • Avoid sources of humming (transformers, motors). To prevent fire or electrical shock, do not expose the speaker to rain or water. • To prevent the enclosure from warping or discoloring, do not place the speaker where it will be exposed to direct sunlight or excessive humidity. • Do not place the following objects on the speakers: Glass, china, etc. If glass etc. falls by vibrations and breaks, it may cause personal injury. A burning candle etc. If the candle falls by vibrations, it may cause fire and personal injury. A vessel with water in it If the vessel falls by vibrations and water spills, it may cause damage to the speaker, and/or you may get an electric shock. • Do not place the speaker where foreign objects such as water drips might fall. It might cause a fire, damage to the speaker, and/or personal injury. • Do not place the speaker where it is liable to be knocked over or struck by falling objects. Stable placement will also ensure better sound performance. • Placing the speaker on the same shelf or rack as the turntable can result in feedback. • When moving the speaker, do not hold the port as it might cause personal injury and/or damage to the speaker. • Any time you note distortion, reduce the volume control on your amplifier to a lower setting. Never allow your amplifier to be driven into “clipping”. Otherwise the speaker may be damaged. • When using an amplifier with a rated output power higher than the nominal input power of the speaker, care should be taken never to exceed the speaker’s maximum input. • Do not attempt to clean the speaker with chemical solvents as this might damage the finish. Use a clean, dry cloth. • Do not attempt to modify or fix the speaker. Contact qualified Yamaha service personnel when any service is needed. The cabinet should never be opened for any reasons. • Secure placement or installation is the owner’s responsibility. Yamaha shall not be liable for any accident caused by improper placement or installation of the speaker. Русский Polski SUPPLIED ACCESSORIES Speaker cable (4 m) x 1 Fastener x 4 NS-C9900 Speaker cable (10 m) x 2 NS-E9900 Fastener (small) x 4 Pad x 4 Bind screw (M4, 10 mm) x 4 Bracket x 2 1 En 2 En NS-C9900 (Center speaker) Place this unit precisely between the front speakers. NS-E9900 (Surround speaker) Place these units behind your listening position. ¦ Setting up the speaker (NS-C9900) Place the speaker above a TV or inside of the TV rack so that the speaker and the TV are aligned vertically. • Do not place the speaker on top of the TV whose area is smaller than the bottom area of the speaker. If placed, the speaker may fall and cause injury. • Do not place the speaker on top of the TV with an inclination. • This speaker features a magnetically shielded design, but there is still a chance that placing it too close to a TV set might impair picture color or create a buzzing noise. Should this happen, move the speaker away from the TV set. PLACING THE SPEAKERS Speaker layout image NS-E9900 Front Subwoofer NS-C9900 Notes Securing this unit Peel off the film from each of the four supplied fasteners and then secure them to the bottom four corners of this unit or the top of the rack, etc. Peal off the film. • Thoroughly wipe clean the surface where the fastener is to be applied. Note that adhesive strength is weakened if the surface is dirty, oily or wet and that this may cause the center speaker to drop. • Do not touch the adhesive surface after peeling off the film as this will weaken its adhesive strength. Fastener ¦ Setting up the speakers (NS-E9900) 4 Hang the speaker by mounting the holes on the Mount the speakers on a wall or place the speakers on a shelf. Determine the best position by following the owner’s manual supplied with your amplifier. Mounting the speakers on the wall 1 Fasten the supplied bracket on the rear panel with screws. Holes 2 Attach the supplied pads in the following indicated positions. Pads Approx. 10 mm Approx. 10 mm Approx. 60 mm Rear panel 3 Fasten two screws into a firm wall or wall support at the interval shown below. Tapping screw (.3.5–4 mm) (Available at the hardware store) Min. 20 mm 3 mm 40 mm Wall/Wall support protruding screws. Make that the screws are securely affixed by the narrow parts of the holes. Caution • Each speaker weighs 4.9 kg. • Do not mount the speakers on thin plywood or a wall composed of a soft surface material. If mounted, the screws may pull out of the flimsy surface and the speakers may fall. This may damage the speakers or cause personal injury. • Do...