Votes - 2, Average rating: 4
(
)
)
|
manual abstract
Refer to instructions with cable kits for proper use. 2 IMPORTANT The anchor point and any hardware used to anchor the speaker must be able to support the speaker’s weight under all conditions. IF YOU ARE NOT SURE OF THE PROPER CAPACITY OF THESE ITEMS TO USE, CONSULT A STRUCTURAL ENGINEER. Mount only one speaker per supplied quick-snap clip. 1. 2. 3. 4. Speaker Wiring Wiring is terminated at a snap-lock input con- nector. There are two positive and two nega- tive terminals to accommodate daisy chaining of speakers in a system. All wiring should be done prior to installation and then plugged into the rear of the speaker. Daisy Chaining The speaker’s snap-lock input connector allows for easy daisy chaining of speakers by providing a second terminal of each polarity. Refer to the figures for proper wiring for daisy chaining of terminals. Speaker Phasing Keep the same polarity terminals wired together to ensure correct phasing. In order to provide the best possible sound, all of the speakers in a system need to be pushing out and pulling in at the same time. If the connections to one speaker in a system are reversed from the others, that speaker’s movement will be out of sync with the other speakers.This will result in a loss of low frequency response and will effect the overall performance of the system. 3 Selecting Power Levels The front-mounted selector switch is used to set the appropriate power level or impedance for your system. Using a small flat-blade screwdriver, turn the knob until the slot points to the power level you require. 70V/100V Systems Both power setting scales for 70V and 100V systems are labeled on the speakers. On the 100V scale, the last position clockwise is marked with a (not available) symbol. Do not use this position in 100V systems. 16. Systems The fully counterclockwise position of the setting switch is the 16-ohm position.This setting is suitable for use with low-impedance amplifiers that typically support 4- or 8-ohm speakers.The speaker’s higher, 16-ohm impedance makes it easier to combine multiple speakers into series - parallel networks while keeping the total system impedance at a level suitable for low-impedance amplifiers. 4 Specifications SPECIFICATIONS 700286198 & 700286206 Frequency Response (-10 dB)* 60 Hz to 19 kHz LF Driver 6-1/2" MDT Metal-Alloy Cone HF Driver 20 mm (3/4") Polycarbonate Dome Sensitivity (1W/1M) 89.5 dBspl (Average 100 Hz -10 kHz) Impedance Ratings Low (16 ohms) / High (70V/100V) Power Input (Max.) 100W @ 16 ohms; 32W @ 70V/100V Power Settings (in watts)† 70V: 32, 16, 8, 4, 2, 1 100V: 32, 16, 8, 4, 2 Enclosure Material ABS Grille Material Powder-Coated Perforated Metal Terminations 4 Terminal Snap-Lock Input Connector Product Weight 10 lb. Speaker Dimensions 15" dia. x 9-1/4" D Included Accessories (1) Snap-Lock Input Connector; (1) Quick-Snap Clip (2) Cable Kits; (3) Nuts; and (3) Suspension Cables with Forged Eye Bolts Enclosure Finish & Color Textured White or Black *Free Space Response, 16-ohm input. † Front panel, switch-selected. 5 ©2003 Bogen Communications, Inc. Specifications are subject to change without notice. 1-877-852-PAGE ...
Other models in this manual:Speakers & Subwoofers - 700286198 (610.26 kb)