Votes - 2, Average rating: 5
(
)
)
|
manual abstract
BE SURE TO OBSERVE CORRECT POLARITY! 4. Insert the speaker into the opening in the wall (or Rough-in Bracket opening) and care- fully tighten each of the six clamping screws, alternating diagonally between each screw position to ensure proper fit. 5. Aim the pivoting tweeter at the listening area. 7. Set the Treble or XOVER switch if applicable. See Setting Switches for details. 8. Replace the speaker grille. Figure 3.11 -Mounting Speakers In Wall © 2007 • All rights reserved. Storm Series In-wall Speakers Setting Switches A62W/A82W TREBLE Switch Once the speakers are wired, mounted, and positioned correctly, use the TREBLE switch (if applicable) to fine-tune the speakers based on local environmental variables such as hardwood floors, thick draperies, etc. Select the “+” position to increase Treble response or select the “-” position if no increase is desired. TREBLE TREBLE Figure 3.12 -TREBLE Switch A82SW XOVER SWITCH The Crossover switch adjusts the upper frequency limit of sound that emanates from the sub- woofer. This switch has three positions: 80Hz, 120Hz, and 180Hz. Correctly setting the XOVER level is paramount to a smooth transition between the main speakers and the subwoofer. Setting this switch too low causes a gap to occur in the audio that makes the main speakers seem disconnected from the bass, an audible separation of sound that does not seem natural. Setting the switch too high causes bass to be produced too strongly because of overlapping frequencies between the main speakers and subwwoofer. This causes a “muddy” sound and reduces the overall clarity of the audio. It is important to experiment with the XOVER switch upon initial setup to obtain the clearest, smoothest sound possible. Try all three settings, and leave the switch in the location it sounds best. See Figure 3-13. 8080120120180180XOVERXOVER Figure 3.13 -XOVER Switch ©2007 • All rights reserved. Storm Series In-wall Speakers 4. Specifications A60W System Type ....................................................................................................................................................................... 2-Way Woofer ........................................................................................................................................................ 6-1/2" Polypropylene Tweeter .............................................................................................................................................................1" Pivoting Mylar Crossover ...................................................................................................................................................................6dB/Octave Impedance ....................................................................................................................................................................... 8 Ohms Sensitivity ..................................................................................................................
Other models in this manual:Speakers & Subwoofers - Storm Series A61W (1.04 mb)
Speakers & Subwoofers - Storm Series A60W (1.04 mb)
Speakers & Subwoofers - Storm Series A60W (1.04 mb)
Speakers & Subwoofers - Storm Series A62W (1.04 mb)