Votes - 0, Average rating: 5 ( )

Manafacture: Alphasonik File size: 1.91 mb File name: Language of manual:

Thinner gauge wire may easily be severed and can cause damage to your system should any bare wire come in contact with the vehicle's chassis. 2. Make sure that your audio system is off while installing and connecting your new Alphasonik speakers. Failure to do so could result in damaging the speaker beyond repair. 3. Be sure to route the wires to the speakers with the insulated terminals ending at the speakers. This will insure a good contact with the speaker. If you need to shorten the speaker lead, do so at the opposite end of the insulated terminals or the bare end. 4. Be sure the polarity is correct at all times. The speaker leads are color-coded for negative and positive. Be sure that the leads are connected to the correct terminal of the speaker. 5. To insure long-term reliability, all bare wires and wire-to-wire connections should be soldered and insulated with heat shrink or electrician's tape. Under no circumstances should you leave any bare wires uncovered, as this can and will lead to the damage of your speakers. 6. When mounting in a door, it is imperative to have the right amount of slack in the connecting wire so it does not get crimped or torn when the door is opened and closed. Avoid areas of the door jam that pinch, this will cause damage to the speaker over long-term use. 7. Once the speaker wiring is completed you can connect the opposite end to the source unit or amplifier. Again, be sure to observe the correct polarity. Solder and wrap all stripped connections. Once you have tested your system and have confirmed that it is operating properly, turn off your system and prepare for the final mounting of the speakers. 1. Position the speaker into the mounting hole and reconfirm the correct mounting location and hole placement. Screw clips are provided to insure a snug fit. Place screw clips over the metal surface and line up the hole with the hole you have previously drilled. Place the speaker into the hole, align the mounting holes and proceed to insert the screws. Be sure to tighten the screws evenly as to not warp the speaker frame. 2. Turn your system back on and confirm the speaker's operation, first at low volume and then you may increase the volume as you desire. 3. The next steps will aid in the proper mounting of the speaker grilles. Follow these steps carefully and be patient. First, locate the special bonding rubber which is located between the waxed paper in the hardware package. 4. Carefully inspect the mounting ring where the grill will be inserted. You will notice 4 to 6 channeled areas. This is the area where the bonding rubber will secure the grill to the speaker. 5. Break off pieces of the bonding rubber that correspond to the size of the channels and insert it snugly in place. Once all of the channels have been filled, carefully insert the grille and press it firmly into place. 8 I N S T A L L A T I O N C O N T I N U E D Grille 9M O U N T I N G D I A G R A M Screw Midbass Grille Ring Speed Clips In the event th...

Download now

Please, enter two numbers from picture: