Votes - 1, Average rating: 3
(
)
)
|
manual abstract
CAUTION: Never operate your grill under any overhead combustible construction. CAUTION:This grill is not intended to be installed in or attached to a recreational vehicle. It is also not intended to be installed in or on a boat. WARNING: Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. Failure to follow this warning could lead to a fire, explosion and bodily harm. Assembly Make sure your grill is assembled properly. Detailed assembly instructions are packed with each grill giving specific assembly procedures for each model. Follow these instructions carefully to ensure the correct and safe assembly of the grill. CAUTION: Although we take every effort to ensure that the assembly process is as easy and as safe as possible, it is inherent with fabricated steel parts that corners and edges can cause cuts if improperly handled during assembly procedures. Be careful while handling any parts during assembly. It is strongly recommended that you protect hands with a pair of work gloves. 24” Leveling It is important for the proper operation of the grill that it be located on a level surface. Grounding Instructions This appliance shall be grounded while in use to protect the operator from electrical shock. The appliance is equipped with a 3-conductor cord and a 3-prong grounding- type plug to fit the proper grounding-type receptacle. Plug into a GFCI-protected outdoor receptacle, where available. Extension Cords Use only 3-wire extension cords that have 3-prong grounding-type plugs and 3-pole cord connectors that accept the plug from the appliance. Only extension cords identified by the marking with the suffix letters W-A, and tagged “Suitable for use with outdoor appliances” shall be used outdoors. Use only extension cords having an electrical rating not less than the rating of the appliance. Do not use damaged extension cords. Examine extension cord before using and replace if damaged. Do not abuse extension cord and do not tug on any cord to disconnect. Keep cord away from heat and sharp edges. CONNECTIONCONNECTION Natural Gas GrillsNatural Gas Grills Type of Gas Your natural gas grill is factory built to operate using natural gas only. Never attempt to operate your grill on gases other than the type specified on the grill rating plates. Your grill operates at 7” of water column pressure. If replacement of the hose becomes necessary, factory specified parts are required. See your local dealer. For safety and design reasons, the conversion of a Ducane® grill from operation using Natural gas to operation using LP gas requires the change out of the entire gas supply system of the grill. If this becomes necessary, see your dealer for additional information. What is Natural Gas? Natural gas, often called methane, is a safe modern fuel. Natural gas is supplied by your local utility and should be readily available if your house is already heated with gas. NATURAL GAS INSTALLER’S GUIDE This guide is a recommendation for natural gas installations. It advises the installer as to the size tubing that is necessary on a natural gas installation depending on how far the grill is located from the house. All tubing should be anticorrosive tin-line copper or an AGA-approved alternate. Operating pressure of the grill is 4.5 water column pressure. This should be verified after the installation is complete. Comparable sized black iron pipe is also acceptable for natural gas lines. Distance 1 - 25 feet Pipe Size 3/8 26 - 50 feet 1/2 51- 100 feet 2/3 of the run 3/4" down to 1/2" 101 feet or more 3/4 CONNECTIONCONNECTION Natural Gas GrillsNatural Gas Grills CONNECTION Natural Gas GrillsNatural Gas Grills Portable Installation Limited portability can be afforded to the grill head when mounted on the portable cart. All grill heads mounted on this portable cart and cabinet model grills so equipped can be moved about 10 feet away from the main gas supply. Ducane recommends moving the grill at least two (2) feet from the gas supply and any combustible surfaces. After the gas supply has been run and checked for leaks in accordance to the assembly instructions, you are ready to grill. To connect the hose to the gas supply, pull back the outer fitting, insert the hose fitting all of the way, and release the outer fi tting. This process will produce a gas joint. Follow special storage instructions located in the Helpful Hints section of this manual for proper care of your grill and its gas hose. Gas Leaks Checks Before operating your grill, check carefully to be certain that all connections are tight and there are no gas leaks. Never use a match or flame for leak detection. Use soapy water or testing solution. Brush the solution on to connection points and look closely for bubbles indicating escaping gas. If leaks are detected, shut off the main gas supply valve and securely retighten connections, then repeat the leak test. . CAUTION: The appliance and its individual shutoff va...
Other models in this manual:Convection Ovens - 2020806 (3.89 mb)