Votes - 3, Average rating: 4.3 ( )

Manafacture: Char-Broil File size: 1.9 mb File name: Language of manual:

Do not remove grease tray until grill has completely cooled. ▲ Cl ea n g ri l l often, preferably after each cookout. If a bristle brush is used to clean any of the grill cooking surfaces, ensure no loose bristles remain on cooking surfaces prior to grilling. It is not recommended to clean cooking surfaces while grill is hot. ▲ Ifyounotice grease or other hot material dripping from grill onto valve, hose or regulator, turn off gas supply at once. Determine the cause, correct it, then clean and inspect valve, hose and regulator before continuing. Perform a leak test. ▲ Keepventilation openings in cylinder enclosure (grill cart) free and clear of debris. ▲ Donotstore objects or materials inside the grill cart enclosure that would block the flow of combustion air to the underside of either the control panel or the firebox bowl. ▲ The regulator may make a humming or whistling noise during operation. This will not affect safety or use of grill. ▲ Ifyouhave a grill problem see the "Troubleshooting Section". ▲ Iftheregulator frosts, turn off grill and LP cylinder valve immediately. This indicates a problem with the cylinder and it should not be used on any product. Return to supplier! f\ CAUTION A Putting out grease fires by closing the lid is not possible. Grills are well ventilated for safety reasons. Do not use water on a grease fire. Personal injury may result. If a grease fire develops, turn knobs and Lp cylinder off. Do not leave grill unattended while preheating or burning off food residue on HI. If grill has not been regularly cleaned, a grease fire can occur that may damage the product. Ignitor Lighting ▲ Donotlean over grill while lighting. 1. Turn OFF gas burner control valves. 2 Turn ON gas source or tank 3. Open lid during lighting.. 4. To ignite, turn the IGNITION BURNER knob to^ HIGH. 5. Push and hold ELECTRONIC IGNITOR button. 6. If ignition does NOT occur in 5 seconds, turn the burner controls OFF, wait 5 minutes, and repeat lighting procedure. 7. Ignite remaining burners by turning to ^ , starting with the burners closest to the IGNITION BURNER first. If ignition still does not occur, follow match-lighting instructions. Lighting instructions continued on next page. 463360408 • 7 A WARNING A Turn controls and gas source or tank OFF when not in use. A CAUTION A If ignition does NOT occur in 5 seconds, turn the burner controls OFF, wait 5 minutes and repeat the lighting procedure. If the burner does not ignite with the valve open, gas will continue to flow out of the burner and could accidently ignite with risk of injury. Match-Lighting ▲ Donotlean over grill while lighting. 1. Open lid. Turn on gas at LP cylinder. 2. Place lit match into match holder (hanging from cart side panel), light burner on right or left side of grill. 3. Push in and turn far right or far left burner knob to HIGH. Be sure burner lights and stays lit. 4. Light adjacent burners in sequence by pushing knobs in and turning to HIGH. Sideburner Ignitor Lighting ▲ Donotlean over grill while lighting. 1. Top cover must be open when burner is operational. 2. To ignite SIDEBURNER, open sideburner cover. 3. Turn sideburner knob to HIGH, push and hold ELECTRONIC IGNITOR button. 4. If sideburner does NOT light in 5 seconds, turn knob to OFF, wait 5 minutes, then repeat lighting procedure. Sideburner Match Lighting 1. Open sideburner cover. 2. Place lit match near burner. 3. Turn sideburner knob to HIGH. Be sure burner lights and stays lit. Burner Flame Check • Remove cooking grates and flame tamers. Light burners, rotate knobs from HIGH to LOW. You should see a smaller flame in LOW position than seen on HIGH. Perform burner flame check on sideburner, also. Always check flame prior to each use. If only low flame is seen refer to "Sudden drop or low flame" in the Troubleshooting Section. HIGH LOW © © © © © © Turning Grill Off • Turn all knobs to OFF position. Turn LP cylinder off by turning hand-wheel clockwise to a full stop. Ignitor Check • Turn gas off at LP cylinder. Press and hold electronic ignitor button. "Click" should be heard and spark seen each time between collector box or burner and electrode. See "Troubleshooting" if no click or spark. Valve Check • Important: Make sure gas is off at LP cylinder before checking valves. Knobs lock in OFF position. To check valves, first push in knobs and release, knobs should spring back. If knobs do not spring back, replace valve assembly before using grill. Turn knobs to LOW position then turn back to OFF position. Valves should turn smoothly. Hose Check • Before each use, check to see if hoses are cut or worn. Replace damaged hoses before using grill. Use only valve/hose/regulator specified by manufacturer. General Grill Cleaning • Do not mistake brown or black accumulation of grease and smoke for paint. Apply a strong solution of detergent and water or use a grill cleaner with scrub brush on insides of grill lid and bottom. Rinse a...

Download now

Please, enter two numbers from picture: