Votes - 4, Average rating: 4.5
(
)
)
|
manual abstract
Remove fireplace grille assemblies by lifting up and out of holes on frame. Then pull from bottom out towards you. (Figures 1 and 2). Note: Lift grille near outer support rods to fully clear holes. Step 2. Insert grille trim onto grille and bend tabs over and around until fully secured (See Figure 3 ). Bend tabs utilizing the flat end of a screw driver or pliers. Step 3. Remove protective covering from decorative grille trim pieces and wipe with damp cloth. Step 4. Replace grills by aligning top ends of rods to upper set of holes on corresponding frames. Swing grilles towards frame in the same manner as they were removed and allow rod bottoms to fall into bottom holes until fully secured. Make sure all rods are completely inside holes. NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. FireCraft Technologies reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for fireplace code information. Printed in U.S.A. © 2000 by FCT P/N 750,054M REV. B 05/2001...
Other models in this manual:Convection Ovens - LK36-P (41.14 kb)
Convection Ovens - LK42-B (41.14 kb)
Convection Ovens - LK42-P (41.14 kb)