Votes - 2, Average rating: 4.5
(
)
)
|
manual abstract
Connect anti-tip bracket to rear range foot. Reconnect the anti-tip bracket, if the range is moved. Failure to follow these instructions can result in death or serious burns to children and adults. IMPORTANT: Read and save these instructions. IMPORTANT : Installer: Leave Installation Instructions with the homeowner. Homeowner: Keep Installation Instructions and anti-tip bracket template for future reference. Save Installation Instructions for local electrical inspector’s use. 30" (76.2 cm) Sealed Burner Gas Freestanding and Slide-in Ranges with self-cleaning thermal/convection oven Before you start... Cabinet opening dimensions Your safety and the safety of others are very important. 25" (63.5 cm) countertop depth (with or without backsplash) and 24" (61 cm) base cabinet depth, 36" (91.4 cm) countertop height We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. Freestanding Range This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING”. These words mean: 7/8" (2.2 cm) min. required between cabinet opening and door or hinge opening. Gas line opening can be located within this shaded 2-1/2" (6.4 cm) 13" (33 cm) max. upper cabinet depth 4" (10.2 cm) min. clearance from both sides of range to 10" (25.4 cm) 2" (5.1 cm) 2-1/2" (6.4 cm) 6" (15.2 cm) floor gas line opening if directly below regulator 9" (22.9 cm) 3" (7.6 cm) 18" (45.7 cm) 24" (61 cm) Outlet should be located within the 18" x 10" (45.7 cm x 25.4 cm) shaded area. For minimum clearance to 30" (76.2 cm) cabinet upper side cabinet cooktop, see ***Note 30" (76.2 cm) opening width opening width 18" (45.7 cm) to countertop DANGER You can be killed or seriously injured if you don’t immediately follow instructions. You can be killed or seriously injured if you don’t follow instructions. side wall or other All safety messages will tell you what the potential combustible material. hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. area. WARNING WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. – Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. – WHAT TO DO IF YOU SMELL GAS • Do not try to light any appliance. • Do not touch any electrical switch • Do not use any phone in your building. • Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions. • If you cannot reach your gas supplier, call the fire department. – Installation and service must be performed by a qualified installer, service agency or the gas supplier. Countertop opening dimensions that are shown must be used. Given dimensions provide required clearances. To eliminate the risk of burns or fire by reaching over heated surface units, cabinet storage space located above the surface units should be avoided. If cabinet storage is to be provided, the risk can be reduced by installing a range hood that projects horizontally a minimum of 5 inches beyond the bottom of the cabinets. Read electrical and carpentry instructions. Proper installation is your responsibility. A qualified technician must install this range. Make sure you have everything necessary for correct installation. It is the customer’s responsibility to make sure that the countertop has been properly prepared and that the installation clearances specified on the model/serial rating plate are met. The model/serial rating plate is located on the oven frame behind the oven drawer. Check location where range will be installed. The range should be located for convenient use in the kitchen. Recessed installations must provide complete enclosure of the sides and rear of range. All openings in the wall or floor where range is to be installed must be sealed. IMPORTANT: Some cabinet and building materials are not designed to withstand the heat produced by the oven for baking and self-cleaning. Check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate or sustain other damage. It is the customer’s responsibility: To contact a qualified electrical installer. Panel A Slide-in Range 7/8" (2.2 cm) min. required between cabinet opening and door or hinge opening. Gas line opening should be located within this shaded area. 4" (10.2 cm) min. clearance from both sides of range to side wall or other combustible material. Outlet should be located within the 18" x 10" (45.7 x 25.4 cm) shaded area. 6" (15.2 cm) 10" (25.4 cm) floor gas line opening if directly below regulator For minimum clearance to cooktop, see ***NOTE 9" (22.9 cm) 24" (61 cm) 18" (45.7 cm) upper side cabinet to countertop 30" (76.2 cm) cabinet ...